Garage Door Torsion Spring Replacement

On your overhead garage door, there are two types of springs. The large and long springs created with heavy-duty metal to support the upper panel of the garage door are known as “extension springs” or “side-mounted springs”.

On the other side, the springs which are connected to the metal plate that is placed and fixed above the garage door opening at the center of the frame and parallel to the surface of the garage door frame are called “torsion springs”. These springs work on the basic principles of twisting and have the support of cables that are connected to each side of a garage door on the lower panel. With the passage of time, they will break. When it concerns replacing garage door torsion springs, you can do it on your own if you know the terms and conditions or have a professional garage door services such as Cincinnati garage door spring repair services to do the job.

It is very important to remember here that conducting garage door spring replacement can be quite a dangerous job if it is not handled with proper care and precautions because the tension stored in the spring can hurt or kill you. You should be highly proficient and use extreme precaution because you could lose your eyes, hand, leg, or even life. This is why it is always suggested that leave this task to the professionals.

In case you want to handle it on your own due to a tight budget, you should consider some important points. Before doing anything with the springs, release the tension in the current springs. Never touch the cable drums. It is good to ensure that you have not to wind off or wind up the torsion springs using a screwdriver.

You will have to insert a bar at first which is well-adjusted into the winding core before doing anything with setscrews. Remember; don’t use a box wrench or a socket for the setscrews. Keep the bar in the center of the cone for conducting torsion spring replacement. Never touch the brackets while wounding the springs.

The procedure to change the torsion spring will be easy if they follow the instructions carefully. Stop the power supply by disconnecting the power cord of the opener. Some older models of garage door openers disconnected from electricity by removing the fuse or flip the circuit breaker. Make sure that you have brought the right type of torsion spring to change the old one. Match the type and dimension of the new spring with the old spring. Never touch the ending cones of torsion springs. Never forget to mark each end of the shaft to balance the garage door after installing a new spring.

Wind of the old and unbroken spring and then remove the securing cones to the mounting brackets. Change and re-install the required hardware. Wind up the new spring properly. Check the balance and alignment of the garage door.  You should apply any high-quality lubricant to eliminate the friction while garage door operations. Reconnect the garage door opener and check if it works or not.